Vai ai contenuti

Menu principale:


Technical-Scientific Instrumental








OUR TECHNICAL ENGINEERING OFFICE HAS MODERN SOFTWARE AND TECHNICAL EQUIPMENT

The principal instrumentation used by the Technical Engineering Office for the analyses and the thermal experimental measurements and acoustics is described hereunder of succession:









n.1 Anemometer to warm thread for the measurement of flows with inclusive speed between 0 m/s and 2 m/s

n.1 Anemometer to warm thread for the measurement of flows with inclusive speed between 0 m/sec and 20 m/s


n.1 Thermo-hygrometer for the simultaneous measurement in real time of:

1) Relative damp (%)
2) Absolute damp (g/mc)
3) Environmental temperature
4) temperature of the dewy point










n. 1 Microwaves sensor for the rapid survey
of damp in depth up to 300 mms with method
not destructive










n. 1 Microwaves sensor for the rapid survey
of damp in depth up to 40 mm with the non-destructive method








n. 1 pyrometer to Infrared with Laser aim for the measure of the temperature superficial without contact




n.1 Thermofluximeter on multi acquisitor with n. 3 probes of temperature for the measurement in work of the Thermal Transmittance U (or factor K) - the evaluation of the trasmittannce in demand for the energetic certification of the buildings from the European Directive 2002/91/CE on the energetic output of the buildings, in accordance with current standards including ANSI, ASTM and ISO.







n. 1 Thermal camera to Infrared for the analyses thermo-graphic in real time and her generation of reports with images in the visible one and in the infrared one to comparison with visualization of the temperatures






n.1 IIC Test Tapping Machine for Field Measurement of Impact Sound Transmission Through Floor-Ceiling Assemblies and Associated Support Structures in accordance with ASTM E1007 and ISO 16283-2, n. 2 Sound Meters Integrator Class 1 with FFT analyzer of the integrated spectrum 1 Octave, 1/3 of Octave and





FFT for Field Measurements in accordance with ISO 16283-1, ASTM E336 and (ANSI)/ASHRAE standards; besides for the measurements of acoustic pollution and environmental and to compile the Technical Report of Evaluation of the risks of exposure to the noise during the job in accordance with ANSI/ASA S3.44-2016/Part1/ISO 1999:2013

Besides the instrumentation above described our Technical Engineering Office it uses of the most modern the software of calculation and analysis post-process existing in commerce.


Torna ai contenuti | Torna al menu